>
>----------------------- Current Status - Port S1
> Status: USERNAME
> Input: 419 Parity Errors: 0
> Output: 256 Framing Errors: 9
> Pending: 0 Overrun Errors: 0
> Modem Status: DCD- CTS+
>
> Active Configuration Default Configuration
> -------------------- ---------------------
> Port Type: Netwrk Netwrk (Dial In)
> Baud Rates: 38400 38400,115200,115200
> Flow Control: RTS/CTS RTS/CTS
> Modem Control: off on
> Modem Config: Configured bleh
>
> Interface: Unassigned (SLIP,Listen)
> Mtu: 0 0
> Dial Group: 0
Couple of things:
Your Modem Control os set to off. If you have modems on all the ports do a
'set all modem on'.
Also you have speed 1, 2 and 3 set to different speeds. Set them all to the
same speed 'set all speed 1 38400', 'set all speed 2 38400', 'set all speed
3 38400'.
Was someone trying to log in when you took this capture? Currently the port
is in username which means someone is loggin in or the carrier detect thinks
someone is connected.
>I'm not sure how to determine the firmwave config. Where is this
>documented or what is the command?
It's ati4, ati5, or ati6 (I can not remember at this moment).
----
Thomas C Kinnen - <tom@lcp.livingston.com>
[Test Engineer - Radius ABM] - LUCENT Technologies RABU
<URL:http://www.livingston.com/> * <URL:http://www.lucent.com/dns/>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>