Jay wrote:
> Hello,
>
> Would there be anyone out there who would know the commands for a DMS
> 10 switch, to provision CT1 for a PM3?
>
> Telco says they dont know what DNIS digits are, and there seems to be a
> signalling problem on the circuit. When calls hit the pm3, the pm3 isnt
> picking them up right away. Delay ranges from 10 seconds up to 5
> minutes before the modem begins negotation.
>
> The other strange symptom is that their test equipment (tbird) isnt
> autodetecting b8zs on the line. Translations dept swears that it is
> setup for b8zs, and when they issue the command that shows the circuit,
> it is configured for 64K BDRT, which they say is the b8zs (clear
> channel) setting.
>
> The pm3 is able to take calls, but users must dial in many times to hit
> the negotiation successfully. Once on, they appear to have a decent
> connection. Connect rates are normal.
>
> Livingston tech support hearing the problem, guessed correctly that we
> are on a DMS 10, and says that we must get the telco to send 1 digit,
> where on other switches, the telco must not send any digits.
>
> Please respond to jay@dam.net, as I am subscribed to portmaster-users in
> digest form.
>
> I am looking for command syntax for setting up a CT1 on a DMS 10.
>
> Thanks,
> Jay Teutenberg
>
> -
> To unsubscribe, email 'majordomo@livingston.com' with
> 'unsubscribe portmaster-users' in the body of the message.
> Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>