Would there be anyone out there who would know the commands for a DMS
10 switch, to provision CT1 for a PM3?
Telco says they dont know what DNIS digits are, and there seems to be a
signalling problem on the circuit. When calls hit the pm3, the pm3 isnt
picking them up right away. Delay ranges from 10 seconds up to 5
minutes before the modem begins negotation.
The other strange symptom is that their test equipment (tbird) isnt
autodetecting b8zs on the line. Translations dept swears that it is
setup for b8zs, and when they issue the command that shows the circuit,
it is configured for 64K BDRT, which they say is the b8zs (clear
channel) setting.
The pm3 is able to take calls, but users must dial in many times to hit
the negotiation successfully. Once on, they appear to have a decent
connection. Connect rates are normal.
Livingston tech support hearing the problem, guessed correctly that we
are on a DMS 10, and says that we must get the telco to send 1 digit,
where on other switches, the telco must not send any digits.
Please respond to jay@dam.net, as I am subscribed to portmaster-users in
digest form.
I am looking for command syntax for setting up a CT1 on a DMS 10.
Thanks,
Jay Teutenberg
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>