Re: (PM) CRC errors

Susan (susan@rockbridge.net)
Wed, 03 Feb 1999 23:53:18 -0500

Did anyone unplug the wires or the boxes to your t1's? or, was anyone
manhandling the equipment? did the power go out?
if so, did you reboot them after?
If you do a reboot, do you still see the problems occur?
--SL

Kimmo Jaskari wrote:
>
> Consider the following:
>
> ---------------------- line0 - E1 Primary Rate ISDN ---------------
>
> Status: UP F1 Framing: CRC4 Encoding: HDB3 PCM: a-law
>
>
> Violations
> -----------------------------
> Bipolar 34
> CRC4 106206
> E-bit 4138
> FAS bit 0
>
> Livingston PortMaster PM-3 ComOS 3.8.2
> System uptime is 6 days 4 hours 56 minutes
>
> Could anyone offer clues as to what is the problem? Telco having fouled
> up PRI's? Bad settings?
>
> I'm not sure what 100000 crc errors in 6 days does to modem stability,
> but I can only assume it's not good.
>
> Kimmo.
> --
>
> ---------------------------------+-------------------------------------+
> Kimmo Jaskari | ÅLCOM - Ålands Datakommunikation Ab |
> E-mail: kimmo@alcom.aland.fi | http://www.alcom.aland.fi |
> http://www.alcom.aland.fi/kimmo | Phone: +358-(0)18-12122 |
> ---------------------------------+-------------------------------------+
>
> -
> To unsubscribe, email 'majordomo@livingston.com' with
> 'unsubscribe portmaster-users' in the body of the message.
> Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>