Any helper on the PRI down under? It is now sitting on the rack doing
@#$% all!
Much appreciate on any info in getting the PRI into the box and it working.
Regards,
Alpha
On Wed, 27 Aug 1997 kbethke@ezy.net wrote:
>
> Well I Just knew if I bought three of these things livingston
> would jump to my help when I needed it.. {sigh} Where else can you
> buy $43k worth of equiptment and not get help.
>
> Perhaps this list will be the saving grace.
>
> Here's the situation. Ive got pm3-2t's with the new modem's,
> upgraded the comos, set them up to the best of my ability, went on
> the LE webpage and went through the quick-start setup guide for the
> PM3 to check myself and it looks like all is well:
>
> > sh line0
> ---------------------- line0 - T1 Primary Rate ISDN ---------------
>
> Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
>
> Receive Level: +2dB to -7.5dB
>
> Alarms Violations
> ----------------------------- -----------------------------
> Blue 0 Bipolar 0
> Yellow 0 CRC Errors 0
> Receive Carrier Loss 0 Multiframe Sync 0
> Loss of Sync 0
>
> Telco claims they dont see any CPE, they can loop the smart jacks
> but nothing is connected to it. Looks like my PM3 see's the telco
> fine. Anyone have any idea what on earth the problem could be?
>
> Oh yea, plug in my As5200 to the same PRI's and all is well.. Can
> PM3's handle PRI's yet? or is that in ComOS 3.8? :)
>
> -Scott
>
> ---
> GSTek Corporation *Kenneth Scott Bethke* Ezy.Net Corporation
> Sun/Networking/ISP Stuff -- BUY/SELL/TRADE -- FAX: 410-742-1381
> Email:kbethke@ezy.net Voice:410-742-1610 Web:http://www.ezy.net/gstek
>