> I received my new PM3's yesterday and put it in place for my new ISP
>(that's going live in a week). It's been an uphill battle since.
>
>First, I couldn't get it to even recognize that my channelized T1's were
>there. (stupid configuration problem on my part) and now when I dial my
>incoming number, it just ring.
>
>Can someone give me any ideas on the next avenue to take. The following is
>the output of my show line(x) commands. I have two channelized t1's. both
>are configured exactly the same so I will include the first line for
>brevity.
>
>---------------------- line0 - T1 Inband DS0 ---------------
>
> Status: UP Framing: D4 Encoding: AMI PCM: u-law
>
> Signaling: Trunk E&ng--M wink start
>
> Receive Level: +2dB to -7.5dB
>
> Alarms Violations
> ----------------------------- -----------------------------
> Blue 0 Bipolar 0
> Yellow 0 CRC Errors 0
> Receive Carrier Loss 0 Multiframe Sync 0
> Loss of Sync 0
>
>Any help would be much appreciated.
>