> I received my new PM3's yesterday and put it in place for my new ISP
> (that's going live in a week). It's been an uphill battle since.
>
> First, I couldn't get it to even recognize that my channelized T1's were
> there. (stupid configuration problem on my part) and now when I dial my
> incoming number, it just ring.
>
> Can someone give me any ideas on the next avenue to take. The following is
> the output of my show line(x) commands. I have two channelized t1's. both
> are configured exactly the same so I will include the first line for
> brevity.
>
> ---------------------- line0 - T1 Inband DS0 ---------------
>
> Status: UP Framing: D4 Encoding: AMI PCM: u-law
>
> Signaling: Trunk E&M wink start
Are you sure it is wink start? D4 AMI is very common on loop start
>
> Receive Level: +2dB to -7.5dB
>
> Alarms Violations
> ----------------------------- -----------------------------
> Blue 0 Bipolar 0
> Yellow 0 CRC Errors 0
> Receive Carrier Loss 0 Multiframe Sync 0
> Loss of Sync 0
>
> Any help would be much appreciated.
>
>
>
>
>
==============================================================
Tim Flavin Internet Access for St Louis & Chicago
Internet 1st, Inc Toll Free Sales & Support 800-875-3173
http://www.i1.net For more information email info@i1.net
==============================================================