First, I couldn't get it to even recognize that my channelized T1's were
there. (stupid configuration problem on my part) and now when I dial my
incoming number, it just ring.
Can someone give me any ideas on the next avenue to take. The following is
the output of my show line(x) commands. I have two channelized t1's. both
are configured exactly the same so I will include the first line for
brevity.
---------------------- line0 - T1 Inband DS0 ---------------
Status: UP Framing: D4 Encoding: AMI PCM: u-law
Signaling: Trunk E&M wink start
Receive Level: +2dB to -7.5dB
Alarms Violations
----------------------------- -----------------------------
Blue 0 Bipolar 0
Yellow 0 CRC Errors 0
Receive Carrier Loss 0 Multiframe Sync 0
Loss of Sync 0
Any help would be much appreciated.