On Wed, 20 Nov 1996, Simon Nuthall wrote:
>
>
> > I am connecting a p25 to a 2e.
> > The p25 will call the 2e and the 2e will then call the p25 back (dont ask
> > (it NYNEX's fault)). I would like to be able to use MP can this be done
> > with out a hunt group on the p25 side?
> > thanks
> > paonia
> >
>
> The P25 can only dial 1 number, so without a huntgroup on the 2e it will
> NOT be able to achieve 128K (2 channels). The 2e with ComOS 3.3.2 and up
> is able to dial multiple numbers from it's location table which would allow
> you to dial each individual number on the P25.
>
> One exception would be if your switch type is 5ess-ptp, then you would get
> a successful connection with both channels. The reason for this is the
> 5ess-ptp will share the same number for both channels unlike any other US
> switch type.
>
> WITHOUT a huntgroup:
>
> P25 --------> PM2e w/5bri = 64K
>
> P25 <-------- PM2e w/5bri = 128K
>
>
> WITH a huntgroup:
>
> P25 --------> PM2e w/5bri = 128K
>
> P25 <-------- PM2e w/5bri = 128K
>
> This is how you would set the location table up to dial two numbers:
>
> add location hq
> set location hq on_demand ( automatic | manual )
> set location hq destination _________ (same IP address as used for
> gateway)
> set location hq netmask 255.255.255.0
> set location hq idletime 2 (2 to 240 minutes, do NOT use 1)
> set location hq group 2
> set location hq username ________ (your username on hq)
> set location hq password ________ (your password on hq)
> set location hq telephone _______&_______ (2 ISDN phone# 's of hq)
> set location hq maxports 2
>
>
> If this is not clear take a look at our appnotes page for this tech note :
>
> http://www.livingston.com/Tech/Appnotes/app.ISDN-oru-quicksetup.shtml
>