First, you *must* have pmreadconf and pmconsole/pminstall. Without them you
can't do this. Since the BSDI software is not out yet, you would need to
use another OS. The PMconsole for Windows can do this if you have a Windows
machine available. (pmreadconf is built in on windows.)
Do a pmreadconf from the old unit. That will creat a binary of all the
settings. Place that in the data directory for pmconsole. Put the new
unit online. First upgrade it with 3.1.4, from our FTP site. Then 'install'
the binary you saved.
Note that because of the higher number of ports, you will have to configure
them too.
Why not pull the 2 expansion cards out of the PM-2e-30 and put them in the
PM-2e-10?
-MZ
-- Livingston Enterprises Technical Support Phone: 800-458-9966 FAX: 510-426-8951 support@livingston.com <http://www.livingston.com/> 6920 Koll Center Parkway #220, Pleasanton, CA 94566