Re: (PM) Chan. T1 Provisioning
Don Lashier (dl@newportnet.com)
Sun, 28 Jun 1998 19:00:28 -0700
On 6/28/98, at 8:12 PM, Tony Schliesser wrote:
>Looking at the port master config guide, I see that I can use FXS (which
>uses immediate start on the PM3) for the signaling (framing and encoding=
are
>not a problem here). If I use the DID thingy BA is talking about, will=
the
>PM3 ignore the "digits" sent used for decoding in a PBX?? Not being up on
>the finer points of telco jargon, I would appreciate any hints, guides,=
etc
>to getting the Chan T1. provisioned correctly for a PM3.
Don't use FXS. Use wink start or immediate start. Have them
set digits to 0 or 1, depends on the switch. This info should
be on livingston's pages somewhere.
Don
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Don Lashier dl@newportnet.com
Newport Internet http://www.newportnet.com/
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>