Re: (PM) IRX-114 and T1 setup problem

Jack Cole (jacole@pcinetwork.com)
Sun, 28 Jun 1998 19:40:21 -0500

>On Sun, 28 Jun 1998, Jack Cole wrote:
>
>> >> Command> show netstat
>> >> Name Ipkts Ierrs Opkts Oerrs Collis Resets Queue
>> >> ether0 0 0 11261 0 0 0 0
>> >> frm1 0 0 30 0 0 0 0
>> >
>> >Hrm.
>> >
>> > Doesn't look like its receiving LMI.
>
>If it wasn't getting LMI the link wouldn't make it to the
>established phase. This part is easy enough to check, set
>console and set debug 0x51 and wait a minute or so. You should
>see something like:
> (W1) Annex-D: Sending Full Status Enquiry - Sequence 104
> (W1) LMI-AnnexD: Received Full Status - Sequence 76
> DLCI List: 17
> (W1) Annex-D: Sending Sequence Exchange - Sequence 105
> (W1) LMI-AnnexD: Received Sequence Exchange - Sequence 77
>If you are getting that you are talking to the switch and it
>looks like the line is coming up.
>
>> Even if my routing tables are screwed up, it should show incoming packets
on
>> the frame port if I try to ping from the outside shouldn't it?
>
>If the other end knows how to talk to this end I would say you
>should be seeing incoming packets. I noticed from your original
>email that you are running RIP over that link. Could RIP be
>causing the routing table at the other end to get hosed?
>
>Hope that this helps.
>

I have tried the debug thing and it is returning the dlci. I don't think
the rip thing would cause a problem since I have another router with the
same config.

Thanks,
Jack

-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>