--- Hot City Internet support@hotcity.com Network Operations Center Unlimited usage SLIP starting at $20/month Voice/Fax 408 848-6012 Serving South Santa Clara & South Santa Cruz CountyOn Fri, 19 Jun 1998 clemdog@marshallnet.com wrote:
> > Ok, so we plugged the T-Berd into the PM3 and nothing. We set the PM3 to > > loopback on (manual) And the T-Berd Saw nothing, of course we did not > > know what to look for or what to enter. And the tech had never done this > > before (T-berd into PM3 that is) > > What should I have seen? > > > > > I am assuming he sent the codes to the Pm3 for the setup for that particular > port. Normally you would set the framing, encoding and then send all zeros > and then all ones from the T-bird and see if the PM3 holds it up or drops off or > does nothing. If it drops off or does nothing then the CSU in the PM3 is bad. I > had one that would drop off and after using a T-bird this was evident. I got that > unit swapped out and had the rep come on over with T-bird on the new unit and > it didn't drop off on the new test. > Jon Clemons > - > To unsubscribe, email 'majordomo@livingston.com' with > 'unsubscribe portmaster-users' in the body of the message. > Searchable list archive: <URL:http://www.livingston.com/Tech/archive/> >
- To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>