Do you have modems in the PM-3? Stupid question but without them
an analog call has no where to go and gets a busy signal from the
PM-3.
Mark Radabaugh
Amplex Internet
support@amplex.net
(419) 833-3635
> -----Original Message-----
> From: owner-portmaster-users@livingston.com
> [mailto:owner-portmaster-users@livingston.com]On
> Behalf Of Franco
> Gasperino
> Sent: Tuesday, May 19, 1998 1:56 PM
> To: 'portmaster-users@livingston.com'
> Subject: (PM) CT1 busy?
>
>
>
> Hello all,
>
> I'm running into a fairly new problem I have searched
> the archives,
> and found a similar problem, but not quite close
> enough to give me
> a solution.
> I have a PM3 with a GTE CT1 connected to line0. I have set up
> line0 with the following:
>
> ---------------------- line0 - T1 Inband DS0 ---------------
>
> Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
>
> Signaling: Trunk E&M wink start
>
> Receive Level: +2dB to -7.5dB
>
> Alarms Violations
> -----------------------------
> -----------------------------
> Blue 0
> Bipolar 0
> Yellow 0 CRC
> Errors 0
> Receive Carrier Loss 0 Multiframe Sync 0
> Loss of Sync 0
>
> Status light on the line0 indicator shows clean,
> however dialing
> into the circut, i receive a busy. Loopbacks are off on line0,
> and GTE has assured me that their switch is set to wink start.
> I have the switch type set to dms-100. All modems are on and
> idling. Any ideas?
>
> Thanks,
> Franco Gasperino
> Icehouse Internet Services
> (509) 444-1590
> -
> To unsubscribe, email 'majordomo@livingston.com' with
> 'unsubscribe portmaster-users' in the body of the message.
> Searchable list archive:
> <URL:http://www.livingston.com/Tech/archive/>
>
>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>