(PM) Injecting RIP into OSPF, Cisc 776 -> PM-3

Doug McClure (closer@scescape.net)
Fri, 8 May 1998 15:37:35 -0400

I have a dial on demand customer who needs routable IPs behind his router
and am attempting since it's a Cisco 776 to use RIP, announce routes to the
PM-3 via RIP and then have the PM-3 redistribute these routes into its OSPF
announcement to the border router instead of a static route. So far, I have
had no luck.

His users entry:

Service-Type = Framed-User,
Framed-Protocol = PPP,
Framed-IP-Address = 209.96.144.185,
Framed-Route = "209.96.148.64 209.96.144.185",
Framed-Routing = Listen,
Filter-Id = "nitz",
Framed-MTU = "1500"

The PMs are setup basically the same - as

set ether0 rip on
Default Routing: Broadcast, Listen (On)

Cisco's setup as

SET USER RemoteNet
SET PROFILE ID 000000000000
SET PROFILE POWERUP ACTIVATE
SET PROFILE DISCONNECT KEEP
SET BRIDGING OFF
SET PASSTHRU OFF
SET 1 AUTO ON
SET 2 AUTO ON
SET 1 NUMBER 6412800
SET 2 NUMBER 6412800
TIMEOUT 1 THRESHOLD 20
TIMEOUT 1 DURATION 0
TIMEOUT 2 DURATION 0
TIMEOUT 1 SOURCE BOTH
TIMEOUT 2 SOURCE BOTH
SET PPP ADDRESS NEGOTIATION LOCAL ON
SET IP ROUTING ON
SET IP ADDRESS 209.96.144.185
SET IP NETMASK 255.255.255.0
SET IP FRAMING NONE
SET IP PROPAGATE ON
SET IP COST 1
SET IP RIP RECEIVE V1
SET IP RIP UPDATE LIN
SET IP RIP VERSION 2
SET IP PAT OFF
SET USER LAN
SET IP ROUTING ON
SET IP ADDRESS 209.96.148.66
SET IP NETMASK 255.255.255.224
SET IP FRAMING ETHERNET_II
SET IP PROPAGATE ON
SET IP COST 1
SET IP RIP RECEIVE V1
SET IP RIP UPDATE PER
SET IP RIP VERSION 2

-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>