Re: (PM) Bipolar and Sync errors

Rick Davidson (rick@buckeyeweb.com)
Thu, 5 Feb 1998 15:37:37 -0500

the errors stopped after removing the NAS-Port-Type = ISDN check item from
the RADIUS entry as well as the Port-Limit = 1. This is a PM3 plugged into
the TELCO smartjack, the cables are fine (both bad simultaneously? I dont
think so) I am positive these errors were caused by PM3 rejecting these
ISDN single channel users. Those 41 million+ errors occured in a span of 4
hours.

Rick Davidson
Buckeye Internet services Ltd.
rick@buckeyeweb.com www.buckeyeweb.com
Voice 440.953.1900 Fax 440.953.1050
Director of Intergalactic Affairs and Interspecies Mediation

-------- snip ----------
> >FYI...
> >Following the out of slots thread, I looked at the stats on my lines and
> >saw the same thing, millions of bipolar errors.
>
> Bipolar errors are usually caused by a defective cable between the
> portmaster and the HDSL modem, or the HDSL modem itself. Hmm, that's
> probably what you call a CSU/DSU right.,
>
> Mike.
> --
> Miquel van Smoorenburg | The dyslexic, agnostic, insomniac lay in his
bed
> miquels@cistron.nl | awake all night wondering if there is a doG
> --
> The From: and Reply-To: addresses are internal mail2news gateway
addresses.
> Reply to the list or to miquels@cistron.nl (Miquel van Smoorenburg)
> -
> To unsubscribe, email 'majordomo@livingston.com' with
> 'unsubscribe portmaster-users' in the body of the message.
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.