Port-Limit = 1
Put that in the RADIUS profile.
>I cannot telnet to one of my pm3s but i can use the pmconsole to get
>there. The telnet port is set correctly at 23 but when i telnet there
>i cannot even get to a prompt. Is there a telnet session going on to
Sounds like you might have hung telnets. Remember 4 is the limit, and
ghosts will take them up.
<URL:http://www.livingston.com/Tech/Technotes/Hardware/command-netconn.shtml>
>that pm3 that is blocking my attempt at a connection? can i disable
>or kill the session from the pmconsole if that is possible? when i was
Actually I don't think so, but I haven't used PMconsole in over a year
I'd say...
>lastly the pmconsole is so dog slow most of the time. what is up with
>that? the usr software i use for my total controls has much less drag
>on my pc as compared to the pmconsole. i like the console better since it
Are you running 3.5.1.4? If so, don't know what to say.
-MZ
-- Lucent Remote Access Division - Chair, Department of Interstitial Affairs Phone: 800-458-9966 510-737-2100 FAX: 510-737-2110 megazone@livingston.com For support requests: support@livingston.com <http://www.livingston.com/> Snail mail: 4464 Willow Road, Pleasanton, CA 94588 - To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message.