Try dialing out of the PM-3 back into itself. If that works that you
can be fairly confident the PRI is ok.
>If I telnet in and watch the connection, I will see the username pop up in
>a "show sessions" screen, but the status is always "DISCONNECTING". If I
>do a "show s#", I will see DISCONNECTING and it will say "Protocol Error".
There was a protocol error - either in the ISDN or PPP. I'd recommend
running a PPP debug - 'set console' 'set debug 0x51' - then dial in.
You can run the results through the PPP Decoder Ring on the Debug Tools
page on our website.
>I don't know if this is a PM issue, or a RADIUS issue. There are no
>entries in the RADIUS accounting log.
The debug should show if it is even getting to the point of authentication.
But I doubt that it is with a protocol error termination.
>I assume that ISDN users can be authenticated from the RADIUS server,
>correct? Do I need any special configuration to do this?
yes and no.
>Also, what are Directory Numbers? Do I need to configure those?
The phone numbers for the PRI, or each DS0. And no, they aren't needed
on PRIs.
-MZ
-- Lucent Remote Access Division - Chair, Department of Interstitial Affairs Phone: 800-458-9966 510-737-2100 FAX: 510-737-2110 megazone@livingston.com For support requests: support@livingston.com <http://www.livingston.com/> Snail mail: 4464 Willow Road, Pleasanton, CA 94588 - To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message.