Re: portmaster won't talk to motorola uta220

Dejan Muhamedagic (muja@galeb.etf.bg.ac.yu)
Wed, 20 Aug 1997 19:26:39 -0400

Tom Samplonius wrote:
>
> On Wed, 20 Aug 1997, Dejan Muhamedagic wrote:
>
> > Hello,
> >
> > Being 5 floors away from the equipment (Motorola UTA220k and Firewall
> > IRX211) I only today found out that two of them are not talking to each
> > other. Very confusing. I used v.35 adapter for a cable (both units are
> > set for the same v.35 protocol) and synchronous connection. However,
> > trying to dial from PMconsole didn't move Motorola at all. It just
> > stood silent. On the other hand, manual dialing from Motorola itself
> > works and I'm able to get V.120 connection at 48kbps (to UUnet's site).
> > However, even that works only from port 2 and, when I try from port 1,
> > UTA220 reports ERROR immediately. I killed 20 hours by now trying to
> > make this work.
> >
> > If there's anybody out there knowing how can I lessen this frustration,
> > I'll be here to listen.
>
> Disable V.120 on the TA. V.120 is only for async connections. You want
> a clear sync channel.
>
> > Thanks.
> >
> > --
> > Dejan Muhamedagic muja@galeb.etf.bg.ac.yu
> >
> >
>
> Tom

I wanted to use a clear channel, but their (UUnet's) ISDN equipment is
set only for V.120. So, when I set clear channel and dialed from
Motorola one of their numbers it was not able to connect. However, I
didn't even get to this point--Motorola doesn't hear what IRX-211 is
talking. I dialed and connected using UTA220k's own keyboard.

-- 
Dejan Muhamedagic        muja@galeb.etf.bg.ac.yu