How do you setup a PM (2E-30's in our case, ComOS 3.5) with assigned
addresses in different subnet than its ethernet port? I understand this
can be done but have not been able to route it successfully. (The other
important nodes on the network are Linux servers, Cisco 2500's, and a
few Ascend ISDN routers. A configuration without OSPF is preferred.)
And, parallel question, how can a Framed-Address dialup be configured to
route properly if it dials in to a PM with an ethernet address and
assigned pool that don't share its subnet?
Pointers to documentation gladly accepted; I haven't found enough yet to
get me there at Livingston's site or in archives of the list. Thanks
very much for your time,
-- Ed Donovan ed@capecod.net