Bad Coffee, too much McDonalds...
Here's the story
IP's X.X.X.2-4
3 workstations behind a
OR-U (3.5L) IP X.X.X.1
OR-U calls into a PM2E30 with BRI card.
Route shows up to the OR-U and we can telnet to it no prob
Routes to workstations don't show up and obviously you can't ping them.
I've tried various Radius configs here's the latest
user Password = "XXX", NAS-Port-Type = ISDN, NAS-IP-Address X.X.X.X
Service-Type = Framed-User,
Framed-Protocol = PPP,
Idle-Timeout = 1800,
Framed-IP-Address = X.X.X.1,
Framed-Route = "X.X.X.2 X.X.X.1 1"
"X.X.X.3 X.X.X.1 1"
"X.X.X.4 X.X.X.1 1"
Any hints or suggestions would be appreciated, excuse any obvious syntax
errors in the above entry.
This is all on the same subnet, they are just using 4 address', should have
been pretty simple. The OR-U is fairly stock, nothing in the routing
tables etc..
David Davies
Director, Internet Services
Buckeye Internet Services, Ltd.
http://www.buckeyeweb.com
"Around the World, through the modem, over the T-1 lines, past the NAP,
nothing but Net...."