On 13 Oct 95 at 9:52, Frank Heinzius wrote:
> On 12 Oct 95 at 9:53, SUPPORT@INTERSTAR COMMUNICATI wrote:
>
> > Hi Phil,
> >
> > What you can do is configure the portmaster port so that you can
> > telnet to the modem, make any configuration changes (such as
> > adjusting modem speed etc) To do this pefrom the following steps
> >
> > telnet to the portmaster and login as !root
> >
> > set s?? service_device telnet 60??
> > set s?? twoway
> > reset s??
> > telnet (portmaster ip) 60??
> >
> The easier way, supposed you use COMOS with a version >= 3.1.2, is to
> login on the PM as !root and then just do a
>
> attach Sx where x is the desired port
>
> Then you may configure the modem. Stop the attach by sending the
> telnet escape character. If you are connected via telnet to the PM,
> enter the telnet escape character and type "send escape".
>
> Be careful! Never attach to a port without a device connected or
> powered on. This _may_ lead to PM lockups.
^^^^^^^^^ off
Of course it must be powered on to be configured. Just a small brain
lag, sorry.
regards,
frank
-- ***** The expressed opinions are totally mine! ***** Frank M. Heinzius MMS Communication GmbH frimp@mms-gmbh.de Eiffestrasse 598 Phone: +49 40 211105-0 Fax: +49 40 210 32 210