how can I re-initialise or reconfigure a dial-in modem attached to a serial
port?
If I remove it, configure it on a PC at the *same* baud-rate as the Portmaster
port everything is OK.
If I reconfigure it at a different baud-rate then it never adapts to the
portmaster port speed and is only capable of sendng garbage to the caller.
If portmaster would send AT\13 then the modem would get the correct speed.
If I can't do this automatically for dial-in ports, is it possible to
do something from the console?
We do not have a system for which "host device" is supported.
Thanks in advance,
Phil