What you can do is configure the portmaster port so that you can
telnet to the modem, make any configuration changes (such as
adjusting modem speed etc) To do this pefrom the following steps
telnet to the portmaster and login as !root
set s?? service_device telnet 60??
set s?? twoway
reset s??
telnet (portmaster ip) 60??
( make your changes and exit by <CTRL> ]
set s?? service device portmaster
set s?? login netowork dialin
reset s??
(Note ?? equals the port number on the portmaster..1 ,2,3
telnet address should be in the range of 6001,6002,6003, etc)
Good Luck
Ted Best
InterStar Communications, Inc.
>
>
> Hi there,
>
> how can I re-initialise or reconfigure a dial-in modem attached to a serial
> port?
>
> If I remove it, configure it on a PC at the *same* baud-rate as the Portmaster
> port everything is OK.
>
> If I reconfigure it at a different baud-rate then it never adapts to the
> portmaster port speed and is only capable of sendng garbage to the caller.
>
> If portmaster would send AT\13 then the modem would get the correct speed.
>
> If I can't do this automatically for dial-in ports, is it possible to
> do something from the console?
>
> We do not have a system for which "host device" is supported.
>
>
> Thanks in advance,
>
> Phil
>
>
>