Just a *tad* backed up. But I am trying to get all of the email that has
backed up worked on. I'm finally pretty much moved in so I should be on
the job fulltime again (overtime, who am I kidding)
>1) How do I backup the Portmaster so if it burns-up I can plop a new one in its place and do a complete recovery?
PMreadconf - it creates a binary image as you said, and you can 'install'
than image into a like piece of equipment. PM2eR->PM2eR but NOT PM2eR->PM2e,
etc. Different hardware, different config file layout.
>2) How do I test this theory(i.e. zero out the config data)?
To set a PM back to factory defaults, from the command line prompt, type
the following:
set console
set register 0xffff 0x0102
You will see some output and the "successfully formatted flash 2"
This will return your PM to factory configuration defaults.
-MZ
-- Livingston Enterprises Technical Support Phone: 800-458-9966 FAX: 510-426-8951 support@livingston.com <http://www.livingston.com/> 6920 Koll Center Parkway #220, Pleasanton, CA 94566