I have the PRi in my pm3 already, I also have everyone configured
into RADIUS. My problem is, PM3 can't seem to make outgoing
calls to my customers piplines. Also, I set the port limit for all
these users to 2, yet no one can open a second channel on
demand. So what gives?
RK
(rkramer@bitwise.net)
From: "Jack Beech" <jwb@nationwide.net>
To: <rkramer@bitwise.net>, <portmaster-users@livingston.com>
Subject: RE: (PM) Replacing pipline400
Date sent: Fri, 24 Dec 1999 13:37:31 -0600
Very simply.. Just get a pm3 and run 2 pri's into it... then setup everyone
up in radius.. thats it... If you have multiple locations, I would suggest
running OSPF.
Jack Beech
President/CEO
Nationwide Internet
http://www.nationwide.net
1-888-Nationwide
> -----Original Message-----
> From: owner-portmaster-users@livingston.com
> [mailto:owner-portmaster-users@livingston.com]On Behalf Of
> rkramer@bitwise.net
> Sent: Friday, December 24, 1999 1:16 PM
> To: portmaster-users@livingston.com
> Subject: (PM) Replacing pipline400
>
>
> To whom it may concern,
>
> I am currently running an ISP with several ISDN Centrex customers
> who are using ascend Pipline 50s to connect to my pipline 400 via
> ISDN PRI. I heard that you could use a PM3 to do the same job as
> my 400. My question is, HOW!?!? I have the extra PM3 and I need
> to ditch the 400. Any suggestions would be most welcome.
>
> Thanks
>
> Rkramer
> (rkramer@bitwise.net)
> -
> To unsubscribe, email 'majordomo@livingston.com' with
> 'unsubscribe portmaster-users' in the body of the message.
> Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>
>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>