I am trying to configure my PM25 to work through two
networks. The scenario is as follows:
1st Network: 210.59.6.0/24
2nd Network: 209.57.38.96/27
I have binded 209.57.38.100 to PM25 ether0,
209.57.38.101 as assigned, netmask 255.255.255.224. My
router has 210.59.6.2, and 209.57.38.97 on e0 Inerface
(209 as secondary). Authentication, Accounting and dns
are all on 210.59.6.0/24 network.
PM Routing table is like this:
0.0.0.0 0 209.57.38.97 local NS 1 ether0
209.57.38.96 27 209.57.38.100 local NL 1 ether0
I can ping to anyone from PM25 and PM25 can be pingged
from anywhere on both networks. But when I connect to
dialup and PM assigns me an address from
209.57.38.96/27 network, I can ping to the same
network but not to other ie 210.59.6.0/24. As my dns
is on this 210 network, I couldn't browse thru dialup.
Further when I try to ping the dialup IP thru router I
couldn't do so while I can ping the PM.
I am not sure if I am doing anything wrong. I would
appreciate any advice/help from you guys.
Thanks and regards,
David
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>