Re: (PM) (Yet another) OSPF question.. (fwd)

Neil Levine (levine@clara.net)
Mon, 22 Feb 1999 15:23:33 +0000

On Mon, Feb 22, 1999 at 04:04:23AM -0800, MegaZone said:
>
> >> on a 2E1 unit with C0 in network mode.
> >C0 9600 off Login USERNAME
>
> Hmm, not sure why it is 61 instead of just 60. Unless the pool size
> was manuall set to 60, or C0 *was* in network mode when booted, and has
> since been changed. The pool is generated at boot.
>
> Only you can confirm if that range *is* the pool.

Yes it is.

> >Default in what sense? To advertise the dial pool via OSPF? I was
> >under the (perhaps mistaken) assumption that the PM3 would only
> >advertise blocks for which you explicitly state an area x advertise
>
> Yes, you are mistaken. No explicit statement is needed to advertise
> the pool.

OK, given this, is there a away to filter out address you dont want
to advertise?

Neil

-- 


--------------------------------------------------------------------
Neil Levine                             ClaraNet(UK) Ltd.
levine@clara.net                        http://www.clara.net
--------------------------------------------------------------------


-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>