Are you actually routing the addresses to the OR-U from the PM-3? Can you
get *to* the PM-3? Run this command on both units (where x.x.x is your C
netblock):
Command> show route x.x.x.240
The OR-U should show a local route to this subnet with itself as the
gateway, and the PM-3 should show a temp route (or static or ospf,
depending on how you're doing it, but not local) for the same subnet with
the OR-U as the gateway.
Also, make sure the destination in the location table entry is either the
PM-3's known address, or set to negotiated.
-James
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>