Re: (PM) Can PM3 pick a certain dial-out channel on PRI?
Steve Weaver (sweaver@inetnebr.com)
Fri, 17 Jul 1998 17:02:52 -0500 (CDT)
> On Fri, 17 Jul 1998, Steve Weaver wrote:
>
> > I'd like to replace this USR piece of junk with a PM3. I need to know
> > if I can set the PM3 to use a certain PRI channel for each dial-out
> > ISDN line. Eg. I have the USR box set so that s22 is the only port in
> > dial group 22. I put the location I want to dial in group 22, and it
> > always uses the same PRI channel to dial-out. Will the PM3 do this or
> > does it just pick any PRI channel (which might not be dial-out
> > capable)?
>
> Yes, you can do this. We do very similiar things with our PM3. We have
> half our PRI in hunt, and the other half is for dialout. We setup the PM3
> to use specific channels for each dialout customer.
>
> The Netserver OS is based on ComOS, which is used in the PM3, so the
> commands should be the same.
Right, but I had to tell the PRI card in the TC box to assign channels
to ports statically, because the default was first call, first modem,
no matter what channel it's on. I didn't know if the PM3 could be
configured this way, since the PM3 doesn't have a stupid PRI card
(that you can't telnet to, but have to hook up a terminal to if you want
to re-configure it, or find out the status of a PRI... Of course you
can do it with the TCM software, but when you don't have a Windows machine,
and don't want to shell out the extra cash for the Solaris version...)
-SW
--
Steven Weaver sweaver@inetnebr.com
Director of Technical Services http://www.inetnebr.com/
Internet Nebraska 402.434.8680
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>