Re: (PM) BACP, b13 and Ascend
Kevin A. Smith (kevin@ascend.com)
Thu, 18 Jun 1998 15:50:41 -0700
At 03:10 PM 6/18/98 -0700, Jon Rust wrote:
>PM3's PRI 3.8b13
>
>It appears that either Ascend or Lucent has bad BACP code. In particular,
>P75s (6.0.2) can connect with one channel, then increase to 2. At some
>point, due to traffic dropping off, or an incoming phone call, the second
>channel drops. After that point, the Ascend can no longer connect a
>second channel. The whole connection has to be dropped and re-iniated.
Is the call attempt being re-made? Is it failing on connection?
I'll set my P85 to BACP and call into the MAX to make sure it's not
a problem there - at least to isolate it a bit.
Kevin Smith Ascend Communications...
Customer Satisfaction ...where Network Solutions never end.
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>