Ether0 config:
Command> sho ether0
Ethernet Status: IP - Enabled IPX - Disabled
Interface Addr: 209.123.47.193
Netmask: 255.255.255.240
Broadcast Address: 209.123.47.207
IPX Network: 00000000
IPX Frame Type: ETHERNET_802.2
Ethernet Address: 00:c0:05:03:2c:51
Routing: RIP(Quiet (Off))
Input Filter:
Output Filter:
Ifconfig:
ether0: flags=106<IP_UP,IPX_DOWN,BROADCAST,PRIVATE>
inet 209.123.47.193 netmask fffffff0 broadcast 209.123.47.207 mtu
1500
ptp4: flags=1ad<IP_UP,IPX_DOWN,POINT_TO_POINT,PRIVATE,COMPRESS>
dest 209.123.12.26 netmask fffffff0 mtu 1500
no, have not tried ptrace at all.
On Sat, 13 Jun 1998, Thomas C Kinnen wrote:
> >I have a user... routed network... lucent ORU
> >128k on_demand dialup.
>
>
> Customer side or your side?
>
> >Their router dials up every minute, idles out at their
> >location-specified idle timeout of 45 seconds, and then
> >reconnects and beings that process all over again.
>
>
> Ok, so their router is dialing out. Can you show us the location entry?
> Also show us the out put of show ether0 and ifconfig.
>
> >on "fetch mail every 1 minute..." but we had them unplug
> >the ethernet, and the router was still dialing up. before
>
>
> Also have you tried ptrace to see what packets are going out? If the router
> is unpluged my guess it is some type or routing update triggering the link.
>
> Tom
>
>
>
>
>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>