Why are you using a local IP? This is abnormal. Is the ISP forcing you to
use this IP for this end of your connection?
Normally the PM's ethernet IP is used and no local IP is set.
> Protocol: PPP Options: Routing, Compression
> Group: 0 Max Ports: 1
You should use a dial group other than 0.
>Idle Timeout: 0 minutes High Mark: 0 bytes
> Mtu: 1500 Async Map: 00000000
> Username: xxxxxx Password: xxxxxx
> Telephone: 9,3016562419
>
>And I configured s11 as follows:
>
> Active Configuration Default Configuration
> -------------------- ---------------------
> Port Type: Netwrk Netwrk (Dial Out) (Security)
> Baud Rates: 38400 38400,38400,38400
Why so slow? I'd expect 115200 here, on all three. This is going to
bottleneck.
> Flow Control: RTS/CTS RTS/CTS
> Modem Control: on on
> Modem Config: Configured usr-off
>
> Interface: Unassigned (PPP,Listen) (PPP,Quiet)
> Mtu: 0 1500
> Async Map: L:00000000 R:00000000 00000000
Hmm - where is the dial group?
-MZ
-- <URL:mailto:megazone@megazone.org> Gweep, Discordian, Author, Engineer, me.. Join ISP/C Internet Service Providers' Consortium <URL:http://www.ispc.org/> "A little nonsense now and then, is relished by the wisest men" 781-788-0130 <URL:http://www.gweep.net/> <URL:http://www.megazone.org/> Hail Discordia! - To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>