I try to set up a location which calls a customer when traffic is for his
location.
Dial in works fine, authenticating with radius:
testtest Auth-Type = System
Service-Type = Framed-User,
Framed-Protocol = PPP,
Framed-IP-Address = 193.141.20.9
Framed-Route = "193.141.20.8/29 0.0.0.0 1"
Framed-Routing = None,
Framed-MTU = 1500
When the customer dials in his 193.141.20.8/29 subnet is connected.
Then I created a location with the same name "testtest", destination
specified, address 193.141.20.9, netmask 255.255.255.248, With PAP,
username, password etc. and as type on_demand. Dialing manually works
fine, the PM3 connects to the customers router and I reach his subnet. But
dialing on demand doesn't work :-( the PM3 sends the packets for the
subnet back to his default router and doesn't make a call ...
So, in the Command Line Administrators Guide I understandd "on_demand"
that the PM3 dials out to the specified location when packets destination
is the customer.
Where is the mistake in my thoughts??
Regards,
Ralf
------------------------------------------------------------------------
Ralf Naegele _/_/_/ _/ _/_/_/
Softwarehaus Engelhardt GmbH _/ _/ _/ Phon: +49 621 5953200
Donnersbergweg 1 _/_/ _/_/_/ _/_/ Fax: +49 621 5953201
D-67059 Ludwigshafen _/ _/ _/ _/ eMail: naegele@she.de
Xlink-PoP LU/HD/KL/DA _/_/_/ _/ _/ _/_/_/ http://www.she.de/
------------------------------------------------------------------------
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>