You got a 2400 bps connect above..?
>
> Here's a typical modem setting (all of the modems are set like this):
>
> -----------------------------------------------------------------------
> Status: IDLE
> Input: 48 Parity Errors: 0
> Output: 36 Framing Errors: 0
> Pending: 0 Overrun Errors: 0
> Modem Status: DCD- CTS+
>
> Active Configuration Default Configuration (* = Host
> -------------------- --------------------- Can Override)
> Port Type: Login/Netwrk Login/Netwrk (Dial In) (Security)
> Login Service: PortMaster PortMaster
> Baud Rates: 115200 115200,57600,38400
> Databits: 8 8
> Stopbits: 1 1
> Parity: none none
> Flow Control: RTS/CTS RTS/CTS
> Modem Control: on on
> Modem Config: Configured multi-v34
> Hosts: default
>
> Terminal Type: vt100
> Login Prompt: Portmaster username:
> Idle Timeout: 60 minutes
> Dial Group: 0
> Login Message: Northwest Link Dedicated Modem Pool
> ----------------------------------------------------------------------
>
>
> PAP is enabled, CHAP was disabled until I turned it on to see if that
> might help, but it's no, so I'll probably turn it back off.
Check your modem config: "show modem multi-v34"
>
> If you have anything that might help, I'm all ears! (or eyes, as the case
> may be ;-))
>
----
Josh Richards - <jrichard@livingston.com> - [Beta Engineer]
LUCENT Technologies - Remote Access Business Unit
(formerly Livingston Enterprises, Inc.)
http://www.livingston.com/
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>