> MZ said:
>
> > 1. A 2 T1 unit can use a max of 49 IPs - 24 per T1 plus C0 if it has a
> > network mode set. This changes depending on line config. I believe
> > if both T1s are set for PRI and C0 isn't network then the pool will be
> > 46. A 2 T1 unit should not, to my knowledge, use 60. That would be a
> > 2 E1 unit.
> >
> > 2. The command to manually set it is 'set pool #'.
>
> The reason I asked... I have the PM3 with 48 modem and a single PRI. I
> expected a maximum of 48 addresses to be used and assigned the IP range to
> start at 206.76.17.211. Once, when I checked the PM3 with a show sessions
> I had a user at 206.76.17.254 and one time when *I* connected I was given
> 206.76.18.1! This really confused me...therefore, my question. I have
> limited the pool size to 46 and that SHOULD fix the problem...
Don't forget the note that if you REDUCE the pool size you must save all
then reboot to have it take effect!
-- Aloha from Paradise,Sherwood
- To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message.