(PM) How many IP addresses does PM3 use? (fwd)

MegaZone (megazone@livingston.com)
Sun, 11 Jan 1998 22:08:16 -0800 (PST)

Once upon a time Tim Winders shaped the electrons to say...
>I have a PM3 with 48 ports. How many IP addresses will this PM3 use? I
>thought it would be limited to 48, but I think it is using 60! Is this
>the case? What was the command to limit the number of IP addresses it
>will use? Thanks...

1. A 2 T1 unit can use a max of 49 IPs - 24 per T1 plus C0 if it has a
network mode set. This changes depending on line config. I believe
if both T1s are set for PRI and C0 isn't network then the pool will be
46. A 2 T1 unit should not, to my knowledge, use 60. That would be a
2 E1 unit.

2. The command to manually set it is 'set pool #'.

-MZ

--
Lucent Remote Access Division - Chair, Department of Interstitial Affairs
Phone: 800-458-9966 510-737-2100 FAX: 510-737-2110 megazone@livingston.com
For support requests: support@livingston.com  <http://www.livingston.com/> 
Snail mail: 4464 Willow Road, Pleasanton, CA 94588
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.