> Hi,
>
> I have two ISDN PRI lines installed, one connecting to a Bay RA 6300 and
> another one using a PM3 and both lines are in the same hunt group. I am
> trying to specify a particular phone number that the digital modems on
> the PM3 should answer on. I have used the "set all directory" command,
> but this seems to only have affected ISDN calls and not calls from pstn
> lines into the digital modems.
Correct. The Digital Modems cannot be tied to specific directory numbers.
The "set all directory" (or "dn") command only affects incoming ISDN
calls, and although it assigns that number to that incoming channel, it
really does very little since each channel on a PRI is really not a
"physical" line.
How many directory numbers were you given for each PRI by the telco? If
you have one for each PRI then somebody dialing the one for the particular
PRI attached to the PM3 should hit it without doing anything special
already. If you only have one directory number for the entire hunt group
(very possible) then you cannot do this. You'd have to have the
telco assign each PRI a number.
Can you elaborate further on what you are trying to accomplish?
>
> Is there a way I can set this up on the PM3?
>
> Regards,
>
>
> Richard Lennerts
> Vianet Australia
>
----
Josh Richards - <jrichard@livingston.com>
Beta Engineer
Lucent Technologies (Remote Access Business Unit)
(previously Livingston Enterprises, Inc.)
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.