This is covered in the manuals. Have you followed the procedures there?
>Global Config
>-------------------
>Default Host: 0.0.0.0
>Alternate Host: 0.0.0.0
>PAP and CHAP are enabled
>Default Route: Broadcast and Listen are checked
>Assigned Address: 0.0.0.0
>I don't even have DNS on the network, do I need it?
I don't think so, since you don't even have the address pool assigned,
unless you are using static IPs.
>User Table
>---------------
>User Type: Login
>Network/Service: Telnet
>Host: Default
This is meaningless if RADIUS is to be used, and this is not a PPP user
in any case.
>Port Config
>----------------
>Port Type: Network/Login: (Have tried just Login with same result)
Login would not allow PPP.
>Login Service: Telnet port 23
>Hardware Flow Control
>Host: Default
> =20
>Most of the other parameters seem normal, but are not verified as =
>correct.
I strongly suggest using the manuals to configure the unit.
-MZ
-- Livingston Enterprises - Chair, Department of Interstitial Affairs Phone: 800-458-9966 510-737-2100 FAX: 510-737-2110 megazone@livingston.com For support requests: support@livingston.com <http://www.livingston.com/> Snail mail: 4464 Willow Road, Pleasanton, CA 94588 - To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message.