Perhaps this list will be the saving grace.
Here's the situation. Ive got pm3-2t's with the new modem's,
upgraded the comos, set them up to the best of my ability, went on
the LE webpage and went through the quick-start setup guide for the
PM3 to check myself and it looks like all is well:
> sh line0
---------------------- line0 - T1 Primary Rate ISDN ---------------
Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
Receive Level: +2dB to -7.5dB
Alarms Violations
----------------------------- -----------------------------
Blue 0 Bipolar 0
Yellow 0 CRC Errors 0
Receive Carrier Loss 0 Multiframe Sync 0
Loss of Sync 0
Telco claims they dont see any CPE, they can loop the smart jacks
but nothing is connected to it. Looks like my PM3 see's the telco
fine. Anyone have any idea what on earth the problem could be?
Oh yea, plug in my As5200 to the same PRI's and all is well.. Can
PM3's handle PRI's yet? or is that in ComOS 3.8? :)
-Scott
--- GSTek Corporation *Kenneth Scott Bethke* Ezy.Net Corporation Sun/Networking/ISP Stuff -- BUY/SELL/TRADE -- FAX: 410-742-1381 Email:kbethke@ezy.net Voice:410-742-1610 Web:http://www.ezy.net/gstek