1) Are you using the right image?
2) Try re-downloading it, make sure ftp is in binary mode
3) Make sure you are using the latest PMconsole (3.5.1.4 for Windows and
3.5.3 for Unix is what you should use, I believe)
4) Try re-flashing it
5) If all of that doesn't work: Don't reboot, call Livingston tech
support.
On Thu, 21 Aug 1997, Robert M. Zachok wrote:
> It's around 11pm EDT, and I was attempting to upgrade a PM2 from 3.5 to
> 3.7 During the upgrade process, I received a message indicating an
> invalid opcode and the upgrade was aborted. At that point the unit was
> dead, so I rebooted it to no avail.
>
> I then attempted to netboot a generic PM2 image, which was successful
> until ComOS started. Then I saw a message:
>
> Invalid length for flash 0/0 - 65535
>
> I'm suspecting that the flash has died. I tried to reformat using
>
> set register 0xffff 0x0102, but the command returned in just a few
> seconds, rather than the 90 seconds the netboot instructions indicated.
>
> I'm desperate! If anyone out there can help, I'd sure appreciate it.
> Please respond directly, since I only receive the digest of this list.