I am a freshman, I apollogise for taking your attention with this
e-mail but I need help and advices in some areas. I need to know why if
I'm following all the steps for the asyn port configuration of ppp dial in
in a portmaster 2E is not working?
Livingston Web Site show the next result of this configuration
letting us know how it should be but the answer I got are not the same. The
right configuration is the next one:
Command> show s1
-------------- Current Status - Port S1------------------
Status: IDLE
Input: 9582 Parity Errors: 0
Output: 3336 Framing Errors: 0
Pending: 0 Overrun Errors: 0
Modem Status: DCD- CTS+
Active Configuration Default Configuration
------------------- ---------------------
Port Type: Netwrk Netwrk (Dial In) (Security)
Baud Rates: 115200 115200,115200,115200
Flow Control: RTS/CTS RTS/CTS
Modem Control: on on
Interface: ptp2 (PPP,Routing,Compr (PPP,Routing,Compress)
Mtu: 0 1500
Async Map: L:00000000 R:00000000 00000000
Dial Group: 0
Command>
What I get is this, please notice the differences in " interface"
----------------------- Current Status - Port S1 ---------------------------
Status: USERNAME
Input: 72 Parity Errors: 0
Output: 126 Framing Errors: 19
Pending: 0 Overrun Errors: 0
Modem Status: DCD- CTS+
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Dial In) (Security)
Baud Rates: 115200 115200,115200,115200
Flow Control: RTS/CTS RTS/CTS
Modem Control: off off
Interface: Unassigned (PPP,Listen) (PPP,Quiet)
Mtu: 0 0
Async Map: L:00000000 R:00000000 00000000
Dial Group: 0
Tanks...
@}-,-`-- @}-,-`-- @}-,-`-- @}-,-`-- @}-,-`-