> OK, I'll give that a try. Is there any way to do it without setting a
> destination IP? If I'm dialing into a rotary with several PMs which aren't
> using reported_ip to report the same destination IP, that could throw a wrench
> into things.
Well, start using reported_ip :)
Or, you could use slip set the destination address to 10.0.0.1 slip
doesn't negotiate the end point address, and doesn't care if it wrong
because it just used for routing.
> Thanks for the tip!
>
> Mark
> --
> Mark Costlow | Personal Contact: | SWCP Information:
> Southwest Cyberport | Mail: cheeks@swcp.com | Mail: info@swcp.com
> Public Access Internet | Voice: +1-505-293-5967 | FTP: ftp.swcp.com:/pub/swcp
> Albuquerque, NM | Fax: +1-505-271-5477 | WWW: http://www.swcp.com/
>
> "Education is never a waste" - Viscount du Valmont
>
>
Tom