Two ports (one BRI) on a 5-BRI card show the following:
--------------------- Current Status - ISDN Port S26 ------------------------
Status: NO-SERVICE
Input: 38974083 Abort Errors: 621
Output: 174402693 CRC Errors: 0
Pending: 0 Overrun Errors: 1
TX Errors: 0 Frame Errors: 126
Modem Status: DCD- CTS+ TELCO+ NT1+ Disconnect:
--------------------- Current Status - ISDN Port S27 ------------------------
Status: NO-SERVICE
Input: 38773769 Abort Errors: 595
Output: 173734147 CRC Errors: 41
Pending: 0 Overrun Errors: 0
TX Errors: 0 Frame Errors: 132
Modem Status: DCD- CTS+ TELCO+ NT1+ Disconnect: invalid Call Ref
This normally refers to the SPIDs being incorrect, but this circuit has
worked for months and has not been modified.
Going into the debug mode shows repeated instances of the following:
S26/S27: Sending Refuse Call - No Ports
S26: Received Disconnect Ack
S26: Received Call Clear
S26/S27: Sending Refuse Call - No Ports
S26: Received Disconnect Ack
S26: Received Call Clear
An incorrect SPID would show up differently here - anyone have a clue
what this means??? Is it the PM or the telco?
========================================================================
Joe Hartley - jh@brainiac.com - brainiac services, inc
PO Box 5069 : Greene, RI : 02827 - vox 401.539.9050 : fax 401.539.2070
Without deviation from the norm, "progress" is not possible. - FZappa