PM2ER

Joshua Barney (josh@bloomnet.com)
Thu, 24 Apr 1997 16:35:58 -0500 (CDT)

OK, I got the routing figured out... sorta... I now can not seem to
resolve any names with DNS... I do have the server set and I can get to
the DNS server by telneting using the IP address... Also I can't seem to
get anywhere with the Asyncs.... I was wondering this. I have two class
C's and usually use the one class C 199.240.129.0 for Serial Ports and
199.240.128.0 for Ethernet and Async. This is what I am doing on the
PM... Is this wrong????

Here are my settings
wausa> show w1
----------------------- Current Status - Port W1
---------------------------
Status: ESTABLISHED
Input: 243789 Abort Errors: 0
Output: 272472 CRC Errors: 0
Pending: 0 Overrun Errors: 0
TX Errors: 0 Frame Errors: 0
Modem Status: DCD+ CTS+

Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Hardwired)
Line Speed: Ext 56K Ext Clock
Modem Control: off off
Local Address: 199.240.129.22 199.240.129.22
Netmask: 255.255.255.252 255.255.255.252
Interface: frmW1 (FRM,Routing) (FRM,Routing)
Mtu: 1500 0
LMI Poll Int: 10 (seconds)
DLCI List: 16:199.240.129.21
Dial Group: 0

System Name: wausa
Default Host: 199.240.128.193
Alternate Hosts:
IP Gateway: 199.240.129.21
Gateway Metric: 1
Default Route: Broadcast, Listen (On)
Name Service: DNS
Name Server: 199.240.128.193
Domain: bloomnet.com
Telnet Access Port: 23
Loghost: 199.240.128.193
Assigned Address: 199.240.128.97
RADIUS Server: 199.240.128.193
Alternate Server: 0.0.0.0
Accounting Server: 0.0.0.0
Alt. Acct. Server: 0.0.0.0
Disabled Modules: SNMP

--Josh

====================================================================
Joshua Barney -- josh@bloomnet.com Northeast Nebraska ComNet
Network Administrator (402) 373-4603
1-800-359-2981
http://www.bloomnet.com