--- ---
Robert H. Hanson LAN/WAN Consultant - Internet Service Provider
Otis Orchards, Wa. Cutting Edge Communications www.cet.com
(509) 927-9541 finger: info@cet.com or email: roberth@cet.com
On Sat, 25 Nov 1995, Arnaud Girsch wrote:
>
> > > Active Configuration Default Configuration
> > > -------------------- ---------------------
> > > Port Type: Netwrk Netwrk (Hardwired)
> > > Line Speed: Ext Clock Ext Clock
> > > Modem Control: on on
> > > Local Address: a.b.c.70 a.b.c.70
> > > Netmask: 255.255.255.0 255.255.255.0
> > > Interface: Unassigned (FRM,Quiet) (FRM,Quiet)
> > > Mtu: 1500 0
> > > LMI Poll Int: 10 (seconds)
> > > DLCI List:
> >
> > if it is frame, should you not have a dlci??
> Yup, it should ...
> If the LMI poll time is wrong (has to be the same at both sides !), then
> it won't get any DLCI ...
> Mine is set to 5 sec.
>
> > also my interface shows
> > Interface: frmW1 (FRM,Routing) (FRM,Routing)
> Yup .. it's also weird, I think, that the interface is unassigned ...
>
> > you can do a
> > set s1 speed 128000 I think
> If my understanding is correct, for a Frame on fractional T1, the speed
> should always be 56k ... and then the CSU/DSU has to be configured to
> have several 56k channels.
> I was told that even for a full T1, it has to be 56k.
>
> hum .. I also have "Modem Control" set to off ... don't know if it really
> makes a difference.
>
> Arnaud.
>
> --
> Arnaud Girsch -+- agirsch@marben.com -+- Marben Products, Inc. - San Jose, CA
>