Dial Script: Send Command Wait for Reply
------------------------------ ------------------------------
ATDP9327891\r CONNECT
\r ogin:
ipbest\r ssword:
secret!\r
pm0> sh loc BETA
Location: BETA Type: Automatic
Destination: Negotiated Netmask: 255.255.255.224
Protocol: PPP Options: Routing, Compression
Group: 1 Max Ports: 1
Idle Timeout: 150 minutes High Mark: 0 bytes
Mtu: 1500 Async Map: 00000000
Dial Script: Send Command Wait for Reply
------------------------------ ------------------------------
ATDP3917321\r CONNECT
\r ogin:
betamax\r ssword:
what?\r
pm0> sh s8
----------------------- Current Status - Port S8 ---------------------------
Status: ESTABLISHED
Input: 2773795 Parity Errors: 0
Output: 4554739 Framing Errors: 0
Pending: 0 Overrun Errors: 0
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Dial In & Out)
Baud Rates: 57600 57600,57600,57600
Flow Control: RTS/CTS RTS/CTS
Modem Control: on on
Modem Status: Configured zyx
Remote Host: 195.81.71.131
Netmask: 255.255.255.224 0.0.0.0
Interface: ptp8 (PPP,Routing,Compr (PPP,Quiet,Compress)
Mtu: 1500 1500
Async Map: L:00000000 R:00000000 00000000
Dial Group: 1
pm0> sh s9
----------------------- Current Status - Port S9 ---------------------------
Status: ESTABLISHED
Input: 24653316 Parity Errors: 0
Output: 8957511 Framing Errors: 0
Pending: 11 Overrun Errors: 0
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Dial In & Out)
Baud Rates: 115200 115200,115200,57600
Flow Control: RTS/CTS RTS/CTS
Modem Control: on on
Modem Status: Configured usr
Remote Host: 195.137.15.34
Netmask: 255.255.255.224 255.255.255.224
Interface: ptp9 (PPP,Routing,Compr (PPP,Quiet,Compress)
Mtu: 1500 1500
Async Map: L:00000000 R:00000000 00000000
Dial Group: 2
No, they have different IP addresses. The PM-2ER had corrupted flash when
shipped from factory, and i had to erase it and make netboot. May be this
is the origin of problem? (I doubt, because everything except second dialer
works ok). Both interfaces use ether0 address.
Best wishes, Paul