Redirect Console Output to a Printer on P0Is your PortMaster(TM) 2 or PortMaster 2E's S0 port in service? If so, you can redirect console message output to a printer on P0 instead. To track any error messages or debug output, you normally set DIP switch #1 (diag) up and connect a terminal to port S0. But leaving the #1 DIP in the up position causes two problems:
To have console output go to a printer on port P0 so you can use the S0 port for service:
Command> set p0 console From then on, until another "set console" command is issued, any output from the PortMaster (generally, it produces very little) is printed in hard copy on your printer. |