PPP user profiles on the PortMaster (TM) user table UPDATED: August 26, 1999 SUMMARY: To add a PPP dialup user to the PortMaster user table from the prompt do the following. Be aware that the PortMaster user table will only hold about 100 users before memory fills up. If you plan to have more than 100 users run RADIUS (TM). BEFORE YOU START: First, make sure that the ports are configured for network dialup. Information on this
setup is available in the ADDING A NETUSER: add netuser [username] [attribute] [value] [attribute] [value] example: add netuser testuser password xyzzy address assigned netmask 255.255.255.0 protocol ppp mtu 1500 These attributes can be applied to the user individually as well: add netuser testuser set user testuser password xyzzy set user testuser address assigned set user testuser netmask 255.255.255.0 set user testuser protocol ppp set user testuser mtu 1500 MAINTAINING THE NETUSERS To view all of your network dial-in users type show table user To view the configuration for an individual user type show user [username] example: show user testuser To remove a user from the netuser table do: delete user [username] example: del user testuser |