ISDN Office Router Quick Setup Guide UPDATED: August 26, 1999 SUMMARY: Here's how to configure your Lucent OR-U (TM) to dial out on demand to a central site. set gateway ____________ # (IP address of the router at central site) set isdn-switch ni-1 #(dms-100 | 5ess | 5ess-ptp) set ether0 address _____________ #(your IP address) set ether0 netmask 255.255.255.0 #(or whatever you're using) set s1 spid ________________ set s1 directory ___________ set s1 group 2 set s2 spid ________________ set s2 directory ___________ set s2 group 2 add location hq set location hq on_demand # (manual | automatic) set location hq destination _________ #(same IP address as used for gateway) set location hq netmask 255.255.255.0 set location hq idletime 2 # (2 to 240 minutes, do NOT use 1) set location hq group 2 set location hq username ________ # (your username on hq) set location hq password ________ # (your password on hq) set location hq maxports 2 set location hq telephone _______ # (ISDN phone# of hq | if dialing 2 numbers specify to numbers 0 with an" &") ie. set location hq telephone <number>&<number> NOTE: only available with or_3.4.2L and above save all On hq you'll add a netuser to the User Table or RADIUS (TM) using the above username and password, protocol PPP, header compression on, address either negotiated or set the same as above. |